Loading ...
Loading ...
Loading ...
WATER FILTER
NOTE : This refrigerator does not require a filter bypass
plug when the filter is not in place.
It is recommended that you replace the water filter:
* Approximately every six months.
* When the water filter indicator turns on.
* When the water dispenser output decreases.
* When the ice cubes are smaller than normal.
1. Remove the old water filter.
Lift up and remove the lower door bin. Swing
the right end of the water filter out of the
compartment and then grasp and rotate the filter
counterclockwise to remove it from the filter head.
2. Replace with a new water filter.
Insert the new filter into the filter head and rotate it
clockwise until the arrow on the new filter lines up with
the arrow on the filter head. Swing the filter back into
the compartment.
* Assemble the door bin.
NOTE: Replacing the water filter could cause a
small amount of water to drain. Place a cup
under the filter head to catch any water.
3. After the water filter is replaced, dispense 2.5
gallons of water (flush for approximately 5 minutes)
to remove trapped air and contaminants from
the system. Do not dispense the entire 2.5 gallon
amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
4. Press and hold the Water Filter button for 3 seconds
to reset the indicator.
,_ CAUTION: Operating the refrigerator with a water
filter is recommended. However, no bypass filter plug
is necessary if there is no water filter installed.
NOTE: To purchase a replacement water filter, visit a
Sears store or call 1-800-4-MY-HOME ®. Also, you may
order on-line at www.sears.com/partsdJrect.
32
Loading ...
Loading ...
Loading ...