Loading ...
Loading ...
Loading ...
TO REPLACE BELT
1. Installnew
belt over
motor drive,
then over
belt pulley.
NOTE: See
PARTS AND
FEATURES Agitator
for belt num-
ber.
Motor
Drive
Pu//ey
End Cap
2. Place agitator
assembly back into
Power-Mate ®.
Cover
Base
3. Line up
front of
cover and
base. Rest
cover on
front edge of
base as
shown.
4. Rotatecover
back. Press
coverfirmlyuntil
side and rear
tabs snap into
place.
Make sure there Side Rear
is no gap Latch Latches
between the cover and base.
5. TurnPower-Mate®upsidedownand
replacetwo (2) coverscrews.
t. Remove Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
Push In
And Turn
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove.
Push In
And Turn
3. Push in and turn
bulb clockwise, to
replace. Bulb must
not be higher than
15 Watts(130 Volts).
4. Reinstall Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
NOTE: See PARTS AND FEATURES for
bulb number.
17
Loading ...
Loading ...
Loading ...