Loading ...
Loading ...
Loading ...
Adjustments
ChuteAssembly
NOTE: Chutes on models with 4-Way Chute Control are also
controlled by the Chute Directional Control. See Fig. 4-1.
The distance snow is thrown can be adjusted by changing the
angle of the chute assembly. To do so:
1. Stop the engine. Refer to the Engine Operator's Manual.
Remove the key and loosen the plastic knob found on the
left side of the chute assembly.
2. Pivot the chute upward or downward before retightening
the wing knob. See Fig. 3-20.
J
Figure 3-20
SkidShoes
The snow thrower skid shoes are adjusted upward at the factory
for shipping purposes. Adjust them downward, if desired, prior
to operating the snow thrower.
CAUTION:It is not recommended thatyou operate
this snow thrower on gravel as it can easily pick up and
throw loose gravel, causing personal injury or damage
to the snow thrower and surrounding property.
For close snow removal on a smooth surface, raise skid
shoes higher on the auger housing.
Use a middle or lower position when the area to be cleared
is uneven, such as a gravel driveway
NOTE: If you choose to operate the snow thrower on a gravel
surface, keep the skid shoes in position for maximum clearance
between the ground and the shave plate.
To adjust the skid shoes:
1. Loosen the four hex nuts (two on each side) and carriage
bolts. Move skid shoes to desired position. See Fig. 3-21.
_. ,,J
Figure :3-21
2. Make certain the entire bottom surface of skid shoe is
against the ground to avoid uneven wear on the skid shoes.
3. Retighten nuts and bolts securely.
SECTION3 -- ASSEMBLY& SET-UP 13
Loading ...
Loading ...
Loading ...