Loading ...
Loading ...
Loading ...
7 | P a g e
1.4 INSTALLATION OF THE HANDLE
To install the handle, please follow these instructions
Carefully pull the door gasket (seal) away from the door in the area where the
handle will be attached.
Place the handle over the screw holes on the outside of the door and attach it
with the screws that have been provided. Tighten the screws.
Press the door gasket back into its groove.
1.5 REVERSING THE DOOR SWING
This appliance has the capability of the door opening from either the left or right side.
The unit is delivered to you with the door opening from the left side. Should you
desire to reverse the opening direction, please follow the instructions below:
1. Carefully lay the appliance on its back. Use cushioning to protect the floor and
appliance.
2. Using a Philips screwdriver, remove the two screws and bottom right hinge
beneath the door. Keep the hinge in a safe place in case you need to reverse
the door again in the future.
3. Carefully slide the door off and place it on a padded surface.
4. Remove the bottom support bracket from the right side.
5. Remove the top right hinge and keep in a safe place in case you want to reverse
the door in the future.
6. Remove the screws from the top left and transfer to the right.
7. Install the top left hinge.
8. Install the bottom left hinge to the door. Do not over-tighten the screw.
9. Rotate the door 180º and relocate it on the top hinge.
10. Install the bottom support bracket.
11. Adjust door alignment. When set, tighten screw on hinge.
Please note: Keep the spare hinge plate(s) to be able to reverse the door back
again.
To prevent damaging the door gasket, make sure you have the door opened fully all
the way before pulling the shelves out.
Loading ...
Loading ...
Loading ...