Loading ...
Loading ...
Loading ...
AS LY
INSTALL THE SHIFTER LEVERTO
® Stand the snow thrower up on the frontof the auger
housing, as shown in Figure 6.
o Cut the plastic tie which holds the shifter lever as-
sembly to the shift bracket°
• Remove the Iocknut, washer, spring and the bolt..
Reposition theshifter lever intothe slot in the control
panel, as shown in Figure 6 and reinstall the bolt,
spring washer and the Iocknut.
® Tighten the Iocknut until1/8" to 3/16" (2or 3threads)
of the bolt protrude past the Iocknuto
• Thread the shifter lever knob onto the threaded end
of the shifter lever until it is tight.
• Move the shifter lever through all the speeds to en-
sure proper tension of the spring. If the shifter Iever
sticks in any of the notches, loosen the Iocknu[ 1/4
turn at a time until the shifter lever moves freely..
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables attached to the auger clutch lever and
traction clutch lever may need to be adjusted before you
use your snow thrower.
For instructions on checking or adjusting the clutch
control cables, see To Adjust The Clutch Control Cables
paragraph on page 18. FIG. 6
9
Loading ...
Loading ...
Loading ...