Loading ...
Loading ...
Loading ...
SERVICE AN
TO REPLACE FRICTION WHEEL
Ifthe snowthrower willnot move forward, and the friction
wheel is worn or damaged, you need to replace it, as
follows:
e Drain the gasoline from the fuel tank by removing
the fuel lineoDrain thefuel and reinstall thefuel line,.
e Disconnect the spark plug wire,
® Stand the snow thrower up on the auger housing
end (See Fig.,32).,
e Remove the bottom panel (See Fig. 29).
e Disconnect the right side track connecting rod,,
ADJUST
LOCKWASHER,
NUT
HEX SHAFT
E TS
FRICTION WHEEL
.T
HUB
BOLT
® Rotate the right side track until it is parallel to the
ground (See Fig 33),,
• Remove the three (3) fasteners securing the friction
wheel to the hub (See Fig. 32).
i i illl
CAUTION: DRAINGASOLINEOUTDOORS
AWAY FROM FIRE OR FLAME.
o Move the shifter lever intofirst (1) gear.
• Loosen the four No_, 10 keps nuts securing the
bearing plate (See Fig..33), Do not remove the nuts.,
NOTE: Reassembly will be easier if you place a piece of
tape over each of the carriage bolt heads on the inside of
the motor mount before you remove the nuts,_
e Move the speed select lever into sixth (6) gear.,
e Remove the four No,,10 keps nuts_
® Remove the bearing plate,
® Slide the hex shaft to the right until the friction wheel
can be removed.
O
O
Install the new friction wheel loosely on the hex
shaft,
Reinstall the removed parts in reverse order of re-
moval
HEX SHAFT
(UNIT STANDING ON
AUGER HOUSING END)
FIG. 33
HUB
NOo 10
NUTS
PLATE
AUGER
HOUSING
21
Loading ...
Loading ...
Loading ...