Loading ...
Loading ...
Loading ...
7
Custom Installation
1. Mark the desired location on
the oor and store the replace
in a safe, dry and dust free
location.
2. Frame an opening of 27.0 in.
(686 mm) wide x 23 ⅜ in. (593
mm) high x 7 ½ in. (191 mm)
deep (Figure 3).
Option #1 - The power cord can
be lead from behind the trim and
along the wall to an outlet near the
replace.
Option #2 - A new outlet can be
installed inside the new frame con-
struction. Plug the unit directly into
a 15 A, 120 V outlet.
!
NOTE: A 15 Amp, 120 Volt
circuit is required. A dedicated
circuit is preferred but not essential
in all cases. A dedicated circuit will
be required if, after installation, the
circuit breaker trips or fuse blows
on a regular basis when the heater
is operating. Additional appliances
on the same circuit may exceed the
current rating of the circuit breaker.
3. Install the provided plastic feet
to the unit as shown in Figure 4.
CAUTION: Clearance for air
circulation beneath the re-
place insert is provided by feet.
Fireplace Installation
Figure 2
Do not install the replace
insert directly on carpet or
similar surfaces which may
restrict air circulation.
CAUTION: If installing the re-
place in a carpeted area, place a
one-piece, solid, at surface under
the replace. Ensure that all of the
feet rest securely on this surface.
4. The rebox is to be installed
Figure 3
27.0 in.
(686 mm)
23 ⅜ in.
(593 mm)
7 ½ in.
(191 mm)
Loading ...
Loading ...
Loading ...