Loading ...
Loading ...
Loading ...
9
11. INSTALL UPPER FLUE MOUNTING BRACKET
12. INSTALL THE HOOD
Center the upper flue mounting bracket with the center line previously
drawn in step 10 and place it flush with the ceiling.
Use the upper flue mounting bracket as a template to mark the position of
its screws.
Drill the 3 screw holes using a 3/16” drill bit.
Insert the included drywall anchors into the drilled holes (1 per hole).
Secure the upper flue bracket to the wall using 3 no. 8 x 3/4” screws.
Ensure that the bracket is tight against the wall.
CAUTION
DO NOT REMOVE the protective plastic film covering the decorative flue (upper & lower) yet.
1. Align the hood and center it above the hood mounting bracket. Gently lower
the hood until it securely engages the bracket, and slightly pull it downward
to make sure it is fully engaged.
2. Level the hood.
3. Mark the position of both holes located inside lower back of hood (as shown
at right). Also mark the position of 2 of the 6 available upper holes (one on
each side). Remove the hood. Drill through both lower holes using a 3/16”
drill bit. Insert the included drywall anchors into both lower drilled holes. Align
the hood and center it above the hood mounting bracket. Gently lower the
hood until it securely engages the bracket, and slightly pull it downward to
make sure it is fully engaged.
NOTE: For horizontal discharge only, make sure the adapter/damper enters
the duct opening and seal joint from inside the hood using 2” metal foil
duct tape.
4. Secure the hood to the wall using 2 no. 8 x 3/4” screws for lower holes, and 2 no. 8 x 1½ for upper holes.
SCREW LOCATIONS
HD0377
C
L
CEILING
MOUNTING BRACKET
EVEN WITH CEILING
WARNING
!
BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
HD0417A
LOWER HOLES LOCATION
UPPER HOLES LOCATION
Ø 3/16” TYP.
SIDE VIEW
NOTE: ILLUSTRATION ABOVE REPRESENTS HORIZONTAL EXHAUST
CONFIGURATION, BUT IT ALSO APPLIES TO VERTICAL
EXHAUST CONFIGURATION.
13. REINSTALL THE BLOWER (HORIZONTAL DISCHARGE ONLY)
1. Position the blower on the inner back of the hood, as shown on the right.
2. Using a 5/16” socket, or a Robertson or a Phillips no. 2 screwdriver and the 4 screws previously
removed, secure the blower to the hood.
NOTE: In order to ease installation, before mounting the blower, prepare the screw holes by
screwing all 4 screws without the blower, then remove and mount the blower.
3. Plug the blower connector back in and plug hood power cord into the outlet.
HD1105
CAUTION
Make sure that the screws are well tightened before continuing the installation.
Loading ...
Loading ...
Loading ...