Loading ...
Loading ...
Loading ...
installation instructions
INSTALLING THE REFRIGERATOR (cont.)
REMOVETHEREFRIGERATORDOORS(cont}
Note:for proper installation later, pleasefollow the next step
carefully.
r_ Remove the tape and keeping the door as
straight as possible, open the door to 90° then lift
straight up to remove it.
Lift up & off
center hinge
Open Door to 90 _'
r_l REMOVE OPPOSITE DOOR
Follow the same procedure on the opposite door,
There are no wires or water lines on the opposite side
REMOVE CENTER HINGE (if necessary)
Remove the 3/8" screws securing the center hinge to the
cabinet.
Use T20 driver to remove outboard screw
Remove
cen[er screw
Loosen Outer
screws
25
r REINSTALLINGTHEREFRIGERATORDOORS
Reversesteps 1 through 4 to reinstall refrigerator, follow
details below for critical alignments.
r_Reinstall center hinge first and torque the screws to 65
in-lbs. With the LH door at 90 ° to the front of
the case, lower the refrigerator door onto the center
hinge. Ensure that the door and hinge align correctly.
rB1Rotate doors closed and make sure moveable center
sealing portion of the door aligns with the striker./fthe
door will not self-close after reinstalling, remove door, turn
door upside down, check alignment mark and arrow,
(there is an alignment mark on the door closure
mechanism/t corresponds to an alignment arrow on
the plastic ring. Rotate door closure mechanism to align
mark and arrow, reinstall door).
Iign fiats with tab.
Underside OF
Fresh Food Door
If door cannot be installed at 90 ° follow steps below:
1. install door at 180 ° to case front
2. If space limits opening door to less than 180 °, then:
a) Remove door, carefully turn door upside down.
b) Check alignment of door closure mechanism shaft on
underside of door. The flats on the shaft should correspond
to alignment tab on plastic ring or mark on bottom end cap.
c) If shaft is not aligned to tab/mark, using 5/32" Allen wrench,
rotate door closure mechanism shaft counterclockwise
for right door and clockwise for left door. Then align
flat with tab/mark.
d) Install the door at 90 _'.
Securely tape the door shut with masking tape or have a
second person support the door. Reinstall the top hinge
and torque the screws to 65 in-lbs.
r_Be sure to reinstall the ground wire and strain relief to the
top hinge.
r_Reinstall hinge cover. NOTE: Ensure wires are not
pinched or under screw bosses before tightening
screws.
Loading ...
Loading ...
Loading ...