Loading ...
Loading ...
Loading ...
NOTE
When ordering your replacement lter,
please reorder the same lter type that is
currently in your refrigerator.
29
Locating the Filters
Your refrigerator is equipped with water ltering
system. The water lter system lters all dis-
pensed drinking water, as well as the water used
to produce ice. The lter is located in the top
right rear corner of the fresh food compartment.
Water Filter
The water lter is located at the top right side
of the fresh food compartment.
Ordering Replacement Filters
To order your replacement lters, please visit
our online store at www.frigidaire.com/store,
by calling toll-free at 1-800-599-7569, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
order extra lters when you rst install your
refrigerator, and that you replace your lters at
least once every 6 months.
Here is the product number to request
when ordering:
PureSource Ultra II
TM
Water Filter
Part #EPTWFU01
Replacing the Water Filter
In general, you should change the water lter
every 6 months to ensure the highest possible
water quality. Water Filter Status on the
user interface prompts you to replace the
lter after a standard amount of water (125
gallons/473 liters for PureSource Ultra II
TM
)
has owed through the system.
If your refrigerator has not been used for a period
of time (during moving for example), change the
lter before reinstalling the refrigerator.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certied for cyst reduction may be used on dis-
infected waters that may contain lterable cysts.
Test & certication results:
• Rated Capacity - 125 gallons/473 liters for
PureSource Ultra II
TM
ice and water lter
• Rated service ow - .65 gallons per minute
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds
per square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your PureSource Ultra II
TM
water lter:
It is not necessary to turn the water supply off
to change the lter. Be ready to wipe up any
small amounts of water released during the
lter replacement.
1. Turn Off the ice maker power switch.
2. Remove the old lter by rotating it counter-
clockwise (to the left) 90 degrees to release it.
3. Slide the old lter cartridge straight out of
the housing and discard it.
4. Unpackage the new lter cartridge. Slide
it into the lter housing as far as it will go
with the grip end horizontal.
5. Push lightly inward on the lter while rotat-
ing it clockwise (to the right). The lter will
then pull itself inward as it is rotated. Rotate
the lter 90 degrees until it stops and the
grip end is vertical. You may be able to feel a
very light click as the lter locks into place.
6. Press a drinking glass against the water
dispenser while checking for any leaks at
the lter housing. Any spurts and sputters
that occur as the system purges air out of
the dispenser system are normal.
7. Continue dispensing water for 3-4 minutes
or until 1.5 gallons of water has owed
through the system. You will likely need to
empty and rell your glass several times.
8. Turn On the ice maker.
9. Press and hold the Water Filter reset
button on the control panel for three
seconds. When the display changes from
Red to Green, the status has been reset.
The PureSource Ultra II
TM
ice and water lter system is
tested and certied to NSF/ANSI
Standards 42, 53 and 401 for the
reduction of claims specied on
the performance data sheet.
More about your Advanced
Water Filter
Filter Cartridge
CHANGING THE FILTER - FRIGIDAIRE PRO
Loading ...
Loading ...
Loading ...