Loading ...
Loading ...
Loading ...
www.usaprocom.com
200204-01B16
INSTALLATION
Use only logs supplied with heater. Each
log is marked with a number. This number
will help you to identify the logs when
installing. Do not place any decorative
cinders on logs or burner.
1. Remove the packing material from the
logs. The log number is marked on the
back of each log.
Refer to Figure 17 for log placement.
2. Place pins on log #1 into two slots in the
rear bracket.
3. Place pin on log #2 into slot on left side of
the middle bracket.
4. Place pin on log #3 into slot on right side
of the middle bracket.
5. Install hole in log #4 onto pin on the left side
of log #1, with one end resting on log #2.
6. Install hole in log #5 onto pin on the right
side of log #1, with one end resting on
log #3.
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation,
and periodically thereafter,
check to ensure that no ame
comes in contact with any log.
With the heater set to high, check
to see if ames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install the logs ex-
actly as instructed. Do not modify logs.
INSTALLING LOGS
Rear Bracket
Log #1
Log #2
Log #4
Log #5
Log #3
Middle Bracket
Figure 17 - Log Installation
Loading ...
Loading ...
Loading ...