Crown XTI1002 User Manual

Loading ...

XTi2 Series Power Ampliﬁers

page 6

Operation Manual

Low Pass Mode

Factory Preset #4: BRG SUBS

Putting the ampliﬁer in BRG SUBS

(bridged subs) mode allows you to

bridge the ampliﬁer for use with a single

8 or 4 ohm subwoofer. The inputs are

automatically summed, a 90Hz 4th order

(24dB/octave) LowPass ﬁlter is enabled,

and the output mode is put into bridge-

mono mode. The XTi2 Series ampliﬁers

come pre-loaded with a preset that makes

it easy to conﬁgure the ampliﬁer for this

operation.

Before you get started ensure that you:

1. Connect signal source to Channel 1 and Channel 2 using XLR connectors (the ampliﬁer inputs will

automatically be summed together when selecting this preset).

2. Connector the speaker as shown.

a. If using the binding post outputs, connect the positive terminal of the speaker to the positive

terminal of Channel 1 and the negative terminal of the speaker to the positive terminal of Channel

b. If using a Speakon

connector, connect the positive terminal of the speaker to 1+ and the

negative terminal to 2+. Plug the connector into the Channel 1 output only.

Follow these quick steps to conﬁgure the ampliﬁer for XOVER operation:

1. Push the “Set/Enter” button and you will see the word “Preset” ﬂashing.

2. Push the “Set/Enter” button again to enter the list of presets in the ampliﬁer.

3. Push the “Next/Down” or “PREV/UP” button until the screen displays “XOVER”.

4. Push the “Set/Enter” button to conﬁrm your selection.

5. The display will now read “XOVER” with the Y icon and XOV icon highlighted.

Get Started

Loading ...

Crown XTI1002 Two-channel, 500-Watt at 4Ω Power Amplifier