Loading ...
Loading ...
Loading ...
XTi2 Series Power Amplifiers
page 4
Operation Manual
Stereo ByPass Mode
XTi 6002 back panel shown.
See page 9 for XTi 1002, 2002
and 4002 back panel.
Stereo DSP Off
This is the default mode the amplifier
is set to from the factory. The amplifier
is configured for stereo mode with all
processing disabled.
1. Connect Left/Right signal source to
Channel 1 and Channel 2 using the
XLR connectors.
2. Connect a speaker to each channel
output using Speakon
®
, Banana
Plugs, or bare wire.
Get Started
Factory Preset #2: BRIDGE
Putting the amplifier in BRIDGE
(bridge-mono) mode delivers the power
of both amp channels into a single 8 or
4 ohm load. The XTi2 Series amplifiers
come pre-loaded with a preset that
makes it easy to configure the amplifier
for this operation.
Before you get started ensure that you:
1. Connect signal source to Channel
1 and Channel 2 using XLR connectors (the amplifier inputs will
automatically be summed together when selecting this preset).
2. Connector the speaker as shown.
a. If using the binding post outputs, connect the positive terminal of the
speaker to the positive terminal of Channel 1 and the negative terminal
of the speaker to the positive terminal of Channel 2.
b. If using a Speakon
®
connector, connect the positive terminal of the
speaker to 1+ and the negative terminal to 2+. Plug the connector into
the Channel 1 output only.
Follow these quick steps to configure the amplifier for BRIDGE operation:
1. Push the “Set/Enter” button and you will see the word “Preset” flashing.
2. Push the “Set/Enter” button again to enter the list of presets in the
amplifier.
3. Push the “Next/Down” or “PREV/UP” button until the screen displays
“Bridge”.
4. Push the “Set/Enter” button to confirm your selection.
5. The display will now read “Bridge” with the Y icon and Bridge
icon highlighted.
Bridge-Mono Mode
NOTE: Custom wiring should
only be performed by qualified
personnel.
Loading ...
Loading ...
Loading ...