Loading ...
Loading ...
Loading ...
PRODUCT DATA SHEETS
Application Guidelines/Water Supply Parameters
It is essential that operational, maintenance, and fi lter
replacement requirements be carried out for the product to
perform as advertised.
Model WF-L200V: The fi lter monitor system measures the
amount of water that passes through the fi lter and alerts
you to replace the fi lter. When 90 % of the fi lter’s rated life is
used, the fi lter indicator light changes from green to yellow.
When 100 % of the fi lter’s rated life is used, the fi lter indicator
light changes from yellow to red, and it is recommended
that you replace the fi lter. Use replacement cartridge L200V
/ NL120V, part #4396702. 2014 suggested retail price of
$32.99 U.S.A./ $49.99 Canada. Prices are subject to change
without notice.
Model WF-NL120V: Change the water fi lter cartridge every
6-9 months. Use replacement cartridge L200V / NL120V,
part #4396702. 2014 suggested retail price of $32.99 U.S.A./
$49.99 Canada. Prices are subject to change without notice.
The product is for cold water use only.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
Refer to the front cover or “Accessories” section for the
Manufacturer’s name, address and telephone number.
Refer to the “Warranty” section for the Manufacturer’s limited
warranty.
Base Grille Water Filtration System
Model WF-L200V capacity 200 gallons (757 liters)
Model WF-NL120V capacity 120 gallons (454 liters)
Tested and certified by NSF International against
ANSI/NSF Standard 42 for the reduction of Chlorine,
Taste and Odor, Particulate Class lll*; and against
ANSI/NSF Standard 53 for the reduction of Lead,
Mercury, Benzene, and p-dichlorobenzene.
This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration of
the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit
for water leaving the system, as specified in ANSI/NSF 42/53.
Chlorine Taste/Odor
Particulate Class
III*
≥ 50 %
≥ 85 %
1.9 mg/L
49,333/mL
2.0 mg/L ± 10 %
At least 10,000
particles/mL
0.07 mg/L
640 mg/L**
0.06 mg/L
312 mg/L
>75.0 %
98.7 %
>75.0 %
99 %
Lead: @ pH 6.5
Lead: @ pH 8.5
Mercury: @ pH 6.5
Mercury: @ pH 8.5
Benzene
p-dichlorobenzene
0.01 mg/L
0.01 mg/L
0.002 mg/L
0.002 mg/L
0.0050 mg/L
0.075 mg/L
0.14 mg/L***
0.15 mg/L***
0.0059 mg/L
0.0054 mg/L
0.0157 mg/L
0.210 mg/L
0.15 mg/L ± 10 %
0.15 mg/L ± 10 %
0.006 mg/L ± 10 %
0.006 mg/L ± 10 %
0.015 ± 10 %
0.225 ± 10 %
0.0014 mg/L
0.0069 mg/L
0.0009 mg/L
0.0007 mg/L
0.002 mg/L
0.0005 mg/L
0.0011 mg/L
0.0042 mg/L
0.0004 mg/L
0.00043 mg/L
0.00083 mg/L
0.0005 mg/L
99.0 %
95.4 %
84.74 %
87.03 %
87.26 %
99.76 %
99.21 %
97.08 %
92.47 %
91.93 %
87.26 %
99.76 %
Substance
Reduction Aesthetic
Effects
Contaminant
Reduction
NSF Reduction
Requirements
NSF Reduction
Requirements
Average
In uent
Average
In uent
In uent
Challenge
Concentration
In uent
Challenge
Concentration
Maximum
Effluent
Maximum
Effluent
Average
Effluent
Average
Effluent
Minimum %
Reduction
Minimum %
Reduction
Average %
Reduction
Average %
Reduction
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 63 °F (17.2 °C).
Water Supply City or Well
Water Pressure 30 - 120 psi (207 - 827 kPa)
Water Temperature 33 °F - 100 °F (0.6 °C - 37.8 °C)
Service Flow Rate 0.5 GPM (1.89 L/min.) @ 60 psi. (413.7 kPa)
Class III particle size: >5 to <15 um
**Test requirement is at least 10,000 particles/mL of AC Fine Test Dust.
***These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
®NSF is a registered trademark of NSF International.
Contaminant NSF Reduction Average Influent Challenge Maximum Average Minimum % Average % Reduction Requirements
Influent Concentration Effluent Effluent Reduction Reduction.
17
05-May-2021 10:43:59 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Loading ...
Loading ...
Loading ...