Loading ...
Loading ...
Loading ...
Installation Instructions
INSTALLING THE WASHER
1. Run some water fl'om the hot and cold timcets to flush
the water lines and remove pmlicles that might clog up
the water \_d\'e screens.
2. Remove the inlet hoses and rubber washers fl'om the
plastic bag and install the rubber washers in each end
of the inlet hoses.
3. (90 ° elbow end)
Carefifllv connect the inlet
hose marked HOT to the
outside "H" outlet ot the
water \:dye. Tighmn by
hand, then tighten another
2/3 turn with pliers.
Careflfilv connect the other
inlet hose to the inside "C"
outlet of the wamr wflve. Tighten by hand; then tighten
another 2/3 turn with pliers. Do not crossthread or
over-tighten these commctions.
4. Connect the inlet hose ends to the HOT and COI,D
water timcets tightly by hand, then tighten another 2/3
ttlFn with pliers. Tm'n the water on and check fin" lea!<s.
5,
6,
Carefldlv move the washer to its final location. Genflv
lifi up on the fl'ont of the washer and slide back.
NOTE: Do not use the dispenser drawer or door to lift
the washe_:
X_]th the washer in its
final position, place a
level on top of the
washer (if the washer
is installed trader a
('o(]nte I', the ,,'_,sh el" __
should not be able to
rock). Ac!just the front
leveling legs up or
down to ensure the washer is resting solid. Turn the
lock nuts on each leg up towards the base of the
washer and snug with a wrench.
NOTE: Kee I) the leg extension at a minimum to
prevent excessive vibration. The timher out the
legs are extended, the more the washer will vibrate.
If the floor is not level or is damaged, you may have
to extend the rear leveling legs. Dn" undercounter
installations, you can ac!itlSt the rear legs by removing
the fl'ont service panel.
15
Loading ...
Loading ...
Loading ...