Loading ...
Loading ...
Loading ...
Apply plumber’s tape
• PPR pipeline installation requires firm welding with special welding equipment.
• This product should not be installed outdoors. It should be located away from
direct sunlight, heat sources, fuel oils, and chemicals.
• Make sure to apply plumber’s tape evenly.
• When tightening the hex nut with a wrench, make sure that other parts are not
turning with it.
• After the filter is installed, check for any water leakage at the joints.
PRODUCT INSTRUCTIONS
• After installation, open the inlet water main valve to allow water flow into the filter.
• Before flushing, ensure that there is a reliable drainage system. You can also
flush the drain water in to a suitable container.
• Turn the drain valve knob to flush the drain.
• Press the on/off button to turn on the auto flushing module (optional) on, then
press the “drain” button to flush the drain.
• Turn the scraper knob clockwise or counterclockwise 3 to 4 times while draining
the water to clean the filter mesh.
• We recommend flushing at least once a week for 30 seconds each time,
depending on the quality of the incoming water.
• To clean the filter cartridge after it has been used continuously for 8-12 months,
remove the stainless steel filter mesh and clean it with a brush or soak it in
vinegar. For best results, we recommend that it be professionally cleaned.
DISASSEMBLING THE FILTER CARTRIDGE
Loading ...
Loading ...
Loading ...