Loading ...
Loading ...
Loading ...
INSTALLATION
REQUIREMENTS
A pedestal may be purchased separately for this washer. This
pedestal will add about 14 inches to the height of your unit for a
total vertical height of approximately 52 inches (132 cm).
Tools and Pa s
Assemble the necessary tools and supplies before beginning the
washer installation. The pads suppled are in the washer drum.
Tools needed for connecting the water inlet hoses
• Pliers (that open to 19/_ in. [39.5 mm])
a Flashlight (optional)
Tools needed for installation
• Open end wrench% in.(17 mm) and 1/2in. (13 mm)
= Level
• Wood block (2" x 4") Optional Pedestal
li Ruler or measuring tape This pedestal is available in three colors:
Parts supplied: White - Part Number 4282
Bisque - Part Number 4284
_ Graphite - Part Number 4286
To order, call your local Sears store or Sears Service Center. For
further information, please reference the service numbers located
on the back page of this manual.
Beadedstrap Transport oit.olepi.g Localon Requirements
A emate Pan You May Need
Parts listed are available from your local Sears store or Sears
Service Center. Please reference the service numbers located on
the back of this manual.
If You Have You Will Need to Buy
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed under acustom counter, or in a
basement, laundry room, closet, or recessed area. (See "Drain
System.")
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
Laundry tub or Sump pump system (if not already
standpipe taller available)
than 96 in. (2.4 m)
Overhead sewer Standard 20 gal. (76 L),30 in. (76.2 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain Siphon break, Part Number 285834;
additional drain hose Part Number
8318155; and connector kit, Part
Number 285835
Drain hose too Drain hose extension kit, Part Number
short 285863
a
A water heater set to deliver 120°F (49°C) water to the
washer.
A grounded electrical outlet located within 5 ft (1.5 m) of
where the power cord is attached to the back of the washer.
(See "Electrical Requirements.")
Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6 kPa).
Water faucets
beyond reach of
fill hoses
2 longer water fill hoses:
6ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008
= A level floor with a maximum slope of 1 in. (2.5 cm) under
entire washer. Installing the washer on carpeting is not
recommended.
• A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 Ibs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
5
Loading ...
Loading ...
Loading ...