Loading ...
Loading ...
Loading ...
4
7. Position the laundry tub and cut the house waste pipe (which should already be installed) to the exact
height. The final height will depend on the waste trap dimensions.
8. Fasten the laundry tub to the wall through any of the holes in the rear flanges. Alternative fastening can
be achieved through the floor. Confirm that the doors operate correctly.
9. Connect the hot and cold from the tap ware to the 3 way ball valves; connect the waste system and the
trap to the laundry tub.
10. Test the laundry tub for leaks. Check the tap ware, washing machine caps and the waste system.
11. Seal the laundry tub to the wall using suitable approved sealant. (Check with your lo
cal council for
building regulations).
Confirm if the washing machine waste inlet needs to be moved from right to left before securing the unit to the
wall. If needed, please see page 5-6 for detailed instructions.
1.
Cold water washing machine required, identify cold water 3 way ball valve confirm that the valve is shut
horizontal and remove the ¾” cap and seal. (Keep the cap in a safe location in case you need to remove the
washing machine at a later date). Feed the cold water hose from the washing machine through the white
plastic washing machine waste inlet to the 3 way ball valve, confirm the seal is okay and then connect them
together.
2. Hot water not required, then checks the cap only and make sure it is tight and that the 3 way ball valve is in
the off position.
3. Hot water washing machine required, identify the cold water 3 way ball valve confirm that the valve is shut
horizontal and then remove the ¾” cap and seal. (Keep the cap in a safe location in case you ne
ed to
remove the washing machine at a later date). Feed the hot water hose from the washing machine through
the white plastic washing machine waste inlet
to the 3 way ball valve, confirm the seal is ok then and
connect them together.
4. Washing machine waste hose connection through the white plastic washing machine waste inlet and make
sure that the hose is as far down the hose as possible and then to prevent the washing machine waste hose
from coming loose use the cable tie from the installation kit to fasten the hose firmly to the white plastic
washing machine waste connector. (see next page for picture)
Important:
Ensure the washing machine outlet hose is correctly fitted at both ends and that the spring clips are firmly in
place to prevent leakage.
Installing the Supertub cont.
Installing the washing machine water inlet and waste outlet
6. Fit the tap ware to the tub using the supplied fittings.
Connect the two flexible hoses onto the body of the
tap ware from the underside; ensure that the flexible
hoses are fitted to the hot and cold correctly. Hand
tightened and then finished with a quarter turn only.
Loading ...
Loading ...
Loading ...