Loading ...
Loading ...
Loading ...
26
Controls and Settings
extra rinse
Use this option when additional rinsing is
desired to remove excess dirt and detergent.
It is recommended for heavily soiled loads or
if household members have sensitive skin.
wrinkle release (on select models)
After the final spin, the washer will perform
a “dry” agitation to loosen the garments
from the side of the drum.
extended refresh (on select models)
Select extended refresh if you will be
unable to remove the load right after the
cycle is complete. The washer recognizes
the load has sat too long and will do a
rinse and spin to keep the load fresh for
up to 12 hours. When you are ready to
remove the load during the extended
refresh segment, you must press cancel
to end the cycle and open the door.
PODS
®
(on select models)
Select this option when using a detergent
pack in a model equipped with a PODS
®
button (on select dispenser only). This
option will divert the flow of water to the
detergent pack compartment optimizing
the detergent pack performance.
Control options
control lock
To lock the controls between cycles,
scroll to the control lock option
and press select. The control lock
icon will show on the LED display. To unlock
the controls scroll to the control lock option
again and press select. Use this feature to
reduce the likelihood of accidental operation
by children. Washer cycles will not run
when control lock is activated.
IMPORTANT
• If steam is selected, rinse temperatures
will be elevated.
• If the wash cycle is paused or
cancelled during a steam cycle, the
door will remain locked until it cools.
You may manually perform a rinse
& spin cycle to cool the internal
temperature sooner.
• During a steam cycle, steam exiting
from the rear vent of the washer is
normal and not cause for alarm.
Wash cycle options
Chime
A signal will sound at the end of each
cycle (and periodically during extended
refresh) if option is activated.
To mute or unmute the chime, press and
hold the select button for 3 sec. This will
not affect any of the other button tones.
options
select
de-select
hold ‘select’ 3 s to mute/unmute
Other features
LED display
delay time
Use delay time to delay the
start of the washing cycle from
30 minutes to 12 hours. To turn
on the delay time option, press
options to scroll to the delay time icon
and press select. Use the cycles button
(300/400 models) or turn the cycle selector
(500/600 models) to select the desired delay
time and press start. The delay time
icon will illuminate on the LED display to
indicate the delay time option is activated.
The time will begin counting down on the
LED display once the washer start/pause
button has been pressed.
PODS
®
is a registered trademark of Procter & Gamble Company, Cincinnati OH, used under license by Electrolux.
The estimated total cycle time will be
displayed when the cycle is selected. The
time may increase if water pressure is low,
oversudsing occurs or the load becomes
unbalanced. The approximate time remaining
will be displayed during the cycle. As the
washer progresses through the cycle phases,
the row of cycle phase indicators lights up
under the cycle time. The eco, control lock,
close door, mute (some models) and delay
time will also appear on this LED display.
Icons may vary according to model.
Loading ...
Loading ...
Loading ...