Loading ...
Loading ...
Loading ...
EN-8
EN
Hair Clipper
SHP 3301BL / SHP 3302RD / SHP 4301BL / SHP 4302RD
2016 05/2016
C
• Turn on the hair clipper by sliding switch A6 to the ON position.
Attention:
The cutting unit A1 will cut off all hair that comes into contact with it, therefore be especially
careful when handling the hair clipper while it is running.
• Cutting without the comb attachment A2 is used primarily for trimming up sideburns and the ear
line and the nape of the neck. When trimming the ear line, hold the hair clipper so that the blade
of the cutting unit A1 points downwards ensuring that only the cutting blades are in contact with
the hair. When trimming the line at the nape of the neck, hold the hair clipper so that the blade
of the cutting unit A1 points downwards. Touch the skin with the cutting blade only very lightly.
• When you have finished using the hair clipper, turn it off by moving switch A6 to the OFF position
and clean it out according to the instructions in the chapter ‘Cleaning and Maintenance’
2.2 TRIMMING A BEARD
• Proceed in the same way as when cutting hair. Trim the beard when it is dry without the use of
shaving gels or foams.
• Trim the beard by slowly moving against the growth direction of the beard, going from the bottom
upwards.
CLEANING AND MAINTENANCE
• Before starting to clean the hair clipper, make sure that it is turned off and disconnected from the
power socket.
• Regular cleaning after every use will ensure optimal performance of the hair clipper.
Attention:
This hair clipper is not designed to be washed under the water tap. Do not spray the hair clipper or
the power adapter A8 with water or any other liquid or submerge it in water or any another liquid.
CLEANING
• Remove the comb attachment A2 from the cutting unit A1 if attached. Hold the hair clipper in your
hand so that your thumb is located on the cutting blade. Use your thumb to push the cutting blade
from the body of the hair clipper A3 until the cutting unit A1 is completely released. Take the cutting
unit A1 off the body of the hair clipper A3. Use the brush A9 to remove all hair or beard remains
from the cutting unit A1 and from the area of the body of the hair clipper A3 underneath the cutting
unit A1. After cleaning, reattach the cutting unit A1 to the body of the hair clipper A3. Position the
cut-out at the foot of cutting unit A1 against the notch on the body of the hair clipper A3 and then
push the cutting unit A1 onto the body of the hair clipper A3 until there is an audible click.
Loading ...
Loading ...
Loading ...