Loading ...
Loading ...
Loading ...
Hair Clipper
SHP 3301BL / SHP 3302RD / SHP 4301BL / SHP 4302RD
EN
EN-7
2016 05/2016
B
• Use the regulator A5 to set the desired hair cut height in the range from 1 to 8 mm. If you
are using the hair clipper for the first time, it is recommended to first try a longer cut and only
thereafter adjust the setting as required.
• Turn on the hair clipper by sliding switch A6 to the ON position.
Attention:
The cutting unit A1 will cut off all hair that comes into contact with it, therefore be especially
careful when handling the hair clipper while it is running.
• To ensure an even haircut, the flat part of the comb attachment A2 must constantly remain in
contact with the scalp. Slowly move the hair clipper against the direction of hair growth.
• Regularly remove hair accumulating in the attachment A2. Prior to removing the hair, turn off the
hair clipper. Hold the attachment A2 by the sides and slide it off in the direction away from the
cutting unit A1. Remove the hair and then attach the attachment A2 back onto the cutting unit
A1. Set the cutting height again, turn on the hair clipper and continue with the haircut.
• When you have finished using the hair clipper, turn it off by moving switch A6 to the OFF position
and clean it out according to the instructions in the chapter ‘Cleaning and Maintenance’.
1.2 TRIMMING A BEARD
• Proceed in the same way as when cutting hair. Trim the beard when it is dry without the use of
shaving gels or foams.
• Trim the beard by slowly moving against the growth direction of the beard, going from the bottom
upwards. Please remember that the comb attachment A2 must constantly remain in contact with
the skin to ensure an even cut. After reattaching the attachment A2 back onto the cutting unit
A1, do not forget to set the cutting height again.
2. TRIMMING WITHOUT THE COMB ATTACHMENT
2.1 CUTTING HAIR
• Use the hair clipper on clean, dry or lightly dampened hair. Before cutting hair, thoroughly comb
out the hair in the direction of growth.
• Seat the person whose hair you will be cutting in such a way that their head is at the height of your
chest. Use a towel to cover the neck and shoulders to protect clothing from hair clippings.
• Hold the comb attachment A2 by the sides and slide it off in the direction away from the cutting
unit A1. When the hair clipper is used without the comb attachment A2, the cut will correspond
to a height of approximately 0.5 mm.
Loading ...
Loading ...
Loading ...