Loading ...
Loading ...
Loading ...
FIGURE 2
FIGURE 3
LEFT
FRONT
REAR
RIGHT
ASSEMBLY
To assemble your' Tiller you will need:
a utility knife
a screwdriver
a hammer'
(1) 7/16" wrench
a pair of pliers
(1) 9/16" wrench
tire pressure gauge
NOTE: THE RIGHT HAND (R,.H.) AND LEFT HAND (LH,)
SIDES OF YOUR TILLER ARE DETERMINED FROM
OPERATOR'S POSITION (FIG,, 2)°
YOUR BAG OF PARTS WILL CONSIST OF THE FOL-
LOWING:
(1) Owners Manual
(1) Handle Lock Lever
(1) Lock Plate
(2) Carriage Bolts 3/8 -
16xl
(1) Dual Cable Clip
(1) Flange Nut 3/8 - 16
(i) Crowntock Nut 1/4 -20
(2) Gripco Nuts 3/8 - 16
(1) Washer 13/32 x
7/8 x 14 Ga.
UNCRATING
" " _'B_ "C"
a Using a utility knife, cut Cardboard A , and
tt tr , " w
D (Fig, 3),.
b, With a screwdriver, pry Top Wood Frame loose at atl
four corners (Fig,, 4).
c, Remove Top Wood Frame,
2_ HANDLE REMOVAL
a, Grasp Handle Assembly as shown in Fig,, 5,
b,. Slowly ease Handle Assembly up and place on top of
crate, NOTE: BE CAREFUL NOT TO KINK CABLES,
co Remove Hairpin Clip from Shift Rod, Remove Shift Rod
from Handle Assembly, Set Shift Rod and Hairpin Clip
aside for later assembly,
3. INSTALL HANDLE
ao Grasp Handle Assembly, ease Handle Base into position
as shown in Fig_s_6 & 7, NOTE; BE CAREFUL NOT
TO STRETCH OR KiNK CABLES,. Route Cables as
shown in Fig, 7,
b_ With Handle Assembly in upward position (Fig, 61 in-
stall the two Carriage Bolts and Locknuts (shipped in
bag of parts),,Tighten Bolts so Handle moves with some
resistance.
HAIRPIN
SHIFT ROD
HANDLE
BRACKET
ASSEMBLY
J
FIGURE 4 _2 - FIGURE 5
Loading ...
Loading ...
Loading ...