Loading ...
Loading ...
Loading ...
Copyright Planika Sp. z o.o. www.planikafires.com IG0033#08 2020-03-20 14
4. OPERATING INSTRUCTIONS
4.1. General Notes
The GaLiO Corten Remote fireplace has a remotely control valve with a built-in ignition for the pilot flame. The flame
height of the main burner may be appropriately regulated by remote control or Touch Panel.
Photo 3: Hand-held transmitter and Touch Panel
4.2. Setting up signal code before using the appliance for the first times
WARNING! You only need to set up the signal code once. It is not necessary when changing the batteries of the hand-
held transmitter or receiver. The appliance is delivered already configured and ready to work.
In case of lost or damaged of hand-held transmitter the new one has to be programmed and the receiver must first
learn the hand-held transmitter’s signal code before the first use:
• Press the “RESET” button on the receiver, and keep this pressed until 2 beeps are heard (See Figure 2). Release
the “RESET” button after the second (somewhat longer) beep.
Press, within 20 seconds, the button (small flame) on the hand-held transmitter, until 2 short beeps are heard.
The signal code has now been set up on the receiver. If, however, a single long beep is heard, this means that setting
the signal code has failed or that the wiring has been connected incorrectly.
Loading ...
Loading ...
Loading ...