Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Machine Power cord not plugged in. Plug inpower cord.
Stops No power at plug. Check electrical source or calI
eIectrician.
Fuse blown or circuit Replace fuse or reset circuit breaker.
breaker open. Ifproblem continues,calI eIectrician.
Using an extension cord. Do not use extension cords.
Timer is not lined up. Turn timer to the right slightly
and pull to start.
Timer knob not pulled out. Set and pullout knob.
Washer at pause in Allow cycIeto continue (see
PERMANENT PRESS IICycle "Operatiing Your Washer').
(approximately two minutes).
Machine is overloaded. Wash smaller Ioads.
Agitator Not The top of the agitator moves This is normal.
Working only in one direction.
The top of the agitator is loose. This is normal.
Water Level The top of the agitator ismuch This is normal.
Too Low/Not higher than the highestwater
Completely level. This creates a perception
Filling of the washer not beingfull
Tub is Tub pulledforward when Ensure tub is centered before
Crooked unloading, starting washer.
Tub moves. This is normal,
Unit not level, Ensure front feet are installed and
nuts aretightened. Levelwasher.
Reset rear legs (see "installation
Instructions,"Section G),
Lint on Load Improper sorting. Sort lint giversfrom linttakers
and by color.
OverIoading. Lint can be trapped in load if
overIoaded. Wash smaller loads.
Paper or tissue in pockets. CIeanout pockets before washing.
Not enough detergent. Use enough detergent to
hold lint in water.
Detergent not dissolving, Use Automatic Temperature Control
Watertemperatures lower (ATC).ATC ensures wash water
than 70°F (21°C). temperature will be warmer than
70°F (21°C).
37
Loading ...
Loading ...
Loading ...