Loading ...
Loading ...
Loading ...
10
6-2. FOR ITEM 61159 AND 61436
While supporting heater, tilt the Head Assembly (B) and slide the
Reflector (A) over the 3 bolts that extend from the Head Assembly.
Use the 3 M8 Wing Nuts (EE) and 3 M8 Washers (GG) to secure the
Reflector to the Head Assembly of the heater. Once you have
tightened the Wing Nuts, return the heater to an upright position.
Hardware Used: 3 x EE, Wing Nut M8
3 x GG, Washer M8
7. Connect the hose and regulator to the LP cylinder. The LP cylinder is
sold separately. Use a standard 20 lb. propane cylinder only. Lift the
Tank Housing (C) up and rest it on the top of the assembled Post Supports (H).
Screw Regulator (E) onto Gas Hose (D). Do not cross thread. Hand tighten securely
then tighten with a wrench. Attach Regulator (E) to valve on LP cylinder and
hand tighten securely. Place LP tank onto base of heater
and secure LP Tank on base by hooking Tank Strap (G)
onto the Post Supports (H). Lower the Tank Housing.
NOTE: Use this heater only with a propane
vapor withdrawal supply system. See chapter 5 of
the standard for storage and handling of liquefied
petroleum gas, ANSI/NFPA 58. Your local library or
fire department should have this book.
6-2
7
ASSEMBLY
Loading ...
Loading ...
Loading ...