Loading ...
Loading ...
Loading ...
Troubleshooting Guide
_The air compressor shouldbeturned off and unpluggedfromthe power source beforeany
mamtenanse is performedas well as the _Jrbtedfrom the tank and the unutallowed time to cool
Persona] inluries could occur from moving pans, _[ectrica] sources,compressed anr,or hot surfaces
PROBLEM POSglBLE CORRECTION
Air leaks at the check valve A defective chsok valve results in s constant air leak at the pressure relief valve
or st the pressure reliefvalve, when there is pressure in the tank and the compressor is shut off. Drain the tank,
then remove and clean or replace the check valve
Air leaks between head and Be sum of proper torqueon head bolts. If leak rem,_ins,contacta servicetsohnician.
cylinder.
Anrleek fromsafety valve. Operate the safety valve manually by pulling on the dng, If the valve continues to
leak when in the closed posibon, tt should be replaced.
Pressure msding on the
regulated pressuregauge
drepswhenanecoeseory_e
used.
Excessivetank pressure.
Motor willnot e_aR,
Excessive moisture _rtthe
discharge sir.
Air leaks from the tank body
ortank welds
If there usan excessive amount of pressure drop when the accessory ns used,
replase the regulator.
NOTE:
Adjustthe regulated pressureunder flow conditions(while accessory is being used).
It is normal for the gauge to show minimal pressure loss dudng _niUaluse of the
tool,
Move the Auto-On/Offlever tothe Off position. If the unit doesn't shut off, unplugit
from the power source end contacta service technician,
Make sure power cord isplugged In and the switchis on. inspectfor the proper size
rues in your circuit box. If the fuse was tnpped, reset Pl and restart the unnt.If
repeated tripping occurs, replace the check valve or contact a service technician,
Remove the water in the tank by draining after each usa. High humidity
environments will cause excessive condensation Utilize water/llter_ on your air
line.
NOTE:
Water condensationis not caused by compressorma]functnon.Be sure the
compreseor'sslr output is greater then your tool's anr coneumptfonrate.
Never drillinto, weld or otherwise modify the airtank or it wnllweaken, The tank can
rupture or explode Compressor cannot be re_nred, DIscontfnue use of the air
compressor,
Loading ...
Loading ...