Loading ...
Loading ...
Loading ...
Avoid Service Checklist
Before you call for service,review this list. It may saveyou time and
expense. The list includescommon occurrencesthat are not the result of
defective workmanship or materials in this appliance.
OCCURRENCE
Range is not level.
This oven is equipped with a state of the art electronic oven controller.
Among its many features is a full time oven circuit diagnostics system. The
controller constantly monitors its internal circuitry as well as several crucial
oven circuits to insure they are all operating correctly. If at any time one of
these systems fails, the controller will immediately stop operation and
begin beeping and flashing an error code of F1 or F3* in the display
window.
POSSIBLE CAUSE/SOLUTION
Poor installation. Placeoven rack in center of oven. Placea levelon the oven rack.
Adjust leveling legsat baseof range until the oven rack is level,
Be sure floor is level and is strong and stable enough to adequately support range.
If floor is sagging or sloping, contact a carpenter to correct the situation.
Kitchen cabinet alignment may make range appear unlevel. Be sure cabinets are
square and have sufficient room for range clearance.
Cannot move appliance easily. Appliance
must be accessible for service.
Cabinets not square or are built in too tightly. Contact builder or installer to make
appliance accessible.
Carpet interferes with range. Provide sufficient space so range can be lifted over
carpet.
*Oven control beeps and displays F1 or Electronic control has detected a fault condition. Push CANCEL to clear the display
F3. and stop the beeping. Reprogram oven. If fault recurs, record fault number, push
CANCEL and contact an authorized Sears servicer.
Surface element too hot or not hot Incorrect control setting. Make sure the correct control is on for the surface
enough, element to be used.
Lightweight or warped pans used. Use only flat, evenly balanced, medium or
heavyweight cookware. Flat pans heat better than warped pans. Cookware
materials and weight of the material affect heating. Heavy- and medium-weight
pans heat evenly. Because lightweight pans heat unevenly, foods may burn easily.
Surface element does not heat.
No power to the appliance. Check steps under "Entire Appliance Does Not Operate_
in this Avoid Service Checklist.
Incorrect control setting. Make sure the correct control is on for the surface
element to be used.
Element not making contact in block. Follow instructions under "Surface Elements
and Drip Bowls" in the General Cleaning section.
Entire appliance does not operate.
Make sure cord/plug is plugged tightly into outlet.
Service wiring isnot complete. Contact your dealer, installing agent or authorized
servicer.
Power outage. Check house lights to be sure. Call your local electric company for
service.
18
Loading ...