Loading ...
Loading ...
Loading ...
REMOVE UNiT FROM CARTON
• Cut from top to bottom all four corners of the carton
and lay panels flat. (See Figure 1)
Remove the lag screw that holds the floating hitch to
the packing skid.
Disassemble and discard carton's wood top and side
supports.
Remove four hex bolt, hex nuts and flat washer from
the hold down brackets at the rear of the carton.
Remove and save the two Flat Washers and Cotter
Pins from the rear axle. Reuse when attaching gauge
wheels.
Discard all other packing hardware and hold down
brackets.
LAG SCREW
WOOD TOP HOLD DOWN
SUPPORTS BRACKET
L
WOOD SIDE "_-_
SUPPORTS
HEX BOLT
PACKING HEX NUT
SKID FLAT WASHER
FIGURE 1
INSTALL TILLER GAUGE WHEELS
Assemble Gauge Wheels onto the Rear Axle with
the extended end of Hub facing inward. Secure with
the Flat Washers and Cotter Pins which you removed
from the axle during unpacking. (See Figure 2.)
COTTER PiN
FLAT WASHER
REAR AXLE
GAGE WHEELS
FIGURE 2
iNSTALL TILLER TINE ASSEMBLIES
Attach the floating hitch to the tractor's draw bar
(Refer to OPERATING INSTRUCTIONS on page 6.)
Remove the preassembled 3/8" x 2" hex bolt and 3/8"
nylock nut from the L.H. Tine Assembly'. Slide the tine
assembly onto the Transmission Axle on the left side
of the tiller and secure with the hex bolt and nylock
nut. (See Figure 3.) Repeat for the R.H. side.
3/8" NYLOCK
NUT
3/8" x 2" AXLE
EDGE HEX BOLT
FIGURE 3
INSTALL (WHEEL) WEIGHTS TO TILLER
NOTE: Weights are not furnished with the Tiller. 30
lb.tractor wheel weights may be purchased to mount
to the Tiller if extra weight is required. (Refer to the
OPERATION section of this manual.)
Remove two Hex Bolts and Nuts from each Tine
Shield, located approximately 3-1/2" from the front
edge. See Figure 4.
Place (Wheel) Weights on Tine Shield and secure
with long Bolts and Nuts furnished with the Weights.
See Figure 4.
LONG_
WHEEL
__ WEIGHT
/ /
FIGURE 4
NUTS
TINE
SHIELD
Loading ...
Loading ...
Loading ...