Loading ...
Loading ...
Loading ...
2
SAFETY PRECAUTIONS
GROUNDING INSTRUCTIONS
General – This carpet spotting machine shall be
grounded while in use to protect the operator from
electric shock. The machine is provided with a
three-contact grounding type attachment plug to fit
the proper grounding type receptacle. The green
(or green & yellow) conductor in the cord is the
grounding wire. Never connect this wire to other
than the grounding pin of the attachment plug.
This machine is for use on a nominal 120-volt
circuit and has a grounding plug that resembles the
plug illustrated in figure below. Make sure that the
machine is connected to an outlet having the same
configuration as the plug. No adapter should be
used with this machine.
Grounded
3 Hole Outlet
Ground Pin
(120V)
This machine is intended for commercial use. It is
constructed for use in an indoor environment and is
not intended for any other use. Use only
recommended accessories.
All operators shall read, understand and exercise
the following safety precautions:
1) Do not operate machine:
- Unless trained and authorized
- Unless you have read and understand operators
manual
- In flammable or explosive areas.
- With damaged or modified cord or plug.
- If not in proper operating condition.
- In outdoor areas.
- In standing water.
- Without filters in place.
- With the use of unapproved extension cords.
2) Before operating machine:
- Make sure all safety devices are in place and
operate properly.
3) When using machine:
- Mix and handle any chemicals according to
manufacturer’s recommendations
- Do not run machine over cord.
- Do not pull machine by cord or plug.
- Do not pull cord around sharp edges or corners.
- Do not unplug by pulling on the cord.
- Do not stretch cord.
- Do not handle plug with wet hands.
- Keep cord away from heated surfaces.
- Do not pick up flammable materials or reactive
metals.
- Report machine damage or faulty operation
immediately.
4) Before leaving or servicing machine:
- Turn off machine.
- Unplug power cord from outlet.
5) When servicing machine:
- Unplug cord from outlet.
- Use manufacturer supplied or approved
replacement parts.
- Avoid moving parts. Don’t wear
loose clothing.
Loading ...
Loading ...
Loading ...