Loading ...
Loading ...
Loading ...
-6-
• Your stove does not draw steadily, smoke rollout occurs, wood burns poorly, or back-drafts occur whether or
not there is combustion present.
• Existing fuel-red equipment in the house, such as replaces or other heating appliances, smell, do not operate
properly, suffer smoke roll-out when opened, or back-drafts occur whether or not there is combustion present.
• Opening a window slightly on a calm (windless) day alleviates any of the above symptoms.
• The house is equipped with a well-sealed vapor barrier and tight tting windows and/or has any powered
devices that exhaust house air.
• There is excessive condensation on windows in the winter.
• A ventilation system is installed in the house.
If an outside air intake is required, you may purchase a FAK-07 vent kit from your local stove dealer and install it
on the rear of the appliance.
FAK-07 INSTALLATION
Installation must adhere to all local codes. If after reading these instructions
you have any doubt about your ability to complete the installation properly,
you must obtain the services of a licensed heating and cooling contractor or
certied wood stove installer.
• Drill a 5” hole through the wall at the desired point of entry. The point of
entry should be at or below the level of the intake air tube on the wood
stove. Slide the tail portion of the weather hood through the hole. Secure
the weather hood with fasteners at each of the four corners. This task should
be done after the stove has been installed and the exhaust piping routed.
Try to position the hole for the air intake as near as possible to the stove.
• Slide both hose clamps over the 5” aluminum ex pipe not included). Then
slide the ex pipe over the air intake tube of the stove. Apply the rst hose
clamp over this end of the aluminum ex hose and tighten.
• Route the ex pipe to the “through wall connection” and slid the ex pipe
over the tail piece. Apply the second hose clamp over the tail piece and
tighten.
NOTE: Fasteners are not provided with this kit. Please obtain fasteners (size
8 x 1-1/2” pan head) that are made for your home’s exterior wall type (i.e.
masonry, wood, ect.).
FAK-07 Kit consists of the following parts: Weather Hood with 5” connector
pipe attached and hose clamps.
SECURING APPLIANCE’S ON A PEDESTAL TO THE FLOOR
Use the designated holes to secure the unit to the oor.
Loading ...
Loading ...
Loading ...