Loading ...
Loading ...
-3-
BLOWER ASSEMBLY
The blower assembly must be disconnected from the
source of electrical supply before attempting the
installation. The blower assembly is intended for use only
with a stove that is marked to indicate such use. Do
not route the supply cord near or across hot surfaces!
Fix the assembly to the back of the stove with the four
screws provided.
ASH PAN
The ash pan is located below the rebox.
FIREBRICK CONFIGURATION
Replace the Firebrick as shown in the illustration.
PEDESTAL BASE ASSEMBLY
1. Assemble the pedestal base skirting. Attach two
corner pieces (A) to the center section (B) of
skirting and secure with four (4) truss head screws.
2. Attach the side skirting sections (C & D) to the
corner pieces and secure with four (4) truss head
screws.
3. Slide the U-shaped skirting assembly around the
pedestal base and secure with two 1/4” long pan
head sheet metal screws at the rear corners.
Assembly
UNPACK AND INSPECT
Remove the packing from the appliance and inspect for any damage. Your appliance is packed with the door
handle spring not installed. Ensure that the bricks are positioned correctly and not broken (see illustration for
proper brick arrangement). Make sure that the bafe board, above the air tubes, is in place and undamaged.
(DO NOT REMOVE).
83172 x 2
X 2
r
X 4
C
D
X 4
B
A
Loading ...
Loading ...
Loading ...