Loading ...
Loading ...
Loading ...
page 9
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable).
Test wall control (optional installation) by locating ON/OFF slider
switch on wall control, then set to the ON position. Test light
and dimmer function and then test fan speeds. Next, locate
handheld remote control. Test the light ON/OFF function by
pressing the L1 button; test the dimmer function by pressing the
L1 button and holding it down for up to 5 seconds. Test fan
speeds with the different fan speed buttons. If the wall and/or
handheld remote control operate(s) all of the functions of the
fan and light, battery/batteries has/have been installed correctly.
If the wall and/or handheld remote control do (does) not
operate all of the fan/light functions, refer to "Troubleshooting"
section to solve any issues before contacting Customer Service.
Fan must be on LOW before setting the fan to reverse direction.
Use the REV button to recirculate air depending on the season.
NOTE: If the wall control/handheld remote control interferes
with other appliances, turn power off first and then go back to
the instructions in Section 11 above.
13. Testing Your Fan.
12. Remote Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
(switch not functional on handheld remote)
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
L2 button - (not applicable for this fan)
REV button - used to REVERSE blade direction
(fan must be set on low before reversing blade
direction)
11
-
22
-
wall control
11
-
22
-
CAUTION: The wall and/or handheld remote control can be programmed to
multiple receivers or fans. If this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on
wall control to the ON position. Within 60 seconds of turning on the wall
control, press and hold the fan OFF button on the wall control for 5 seconds
(or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds and then turn power back on.
Within 60 seconds of restoring the power, press and hold the OFF button on
the front of the handheld remote control for 5 seconds (or until light blinks
twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete--
see Section 13 below.
handheld
remote control
11
-
22
-
11
-
22
-
11. Automated Learning Process./Activating Code.
Loading ...
Loading ...
Loading ...