Loading ...
Loading ...
Loading ...
SECTION3: HARDWAREPACK
Please identify each piece of the hardware pack as
shown in Figure 1.
Figure 1
Wing Nut 1/4-20 (2) Carriage Bolt 1/4-20 (2)
SECTION4: UNPACKING
RemovingUnitFromCarton
Remove staples, break glue on top flaps, or cut
tape at carton end and peel along topflap to open
carton.
Remove loose parts included with unit (i.e.,
operator's manual, oil, etc.).
Cut corners and lay carton clown flat. Remove
packing matedaL
Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
NOTE: Make sure not to crimp the cables while
removing the loose parts or the entire unit from the
carton.
NOTE: Reference to right or left hand side of the mower
and/or front or behind the mower is observed from the
operating position.
SECTION5: ASSEMBLINGYOURLAWNMOWER
ToolsRequired
Pair of Pliers
Funnel
Set of adjustable wrenches
DisconnectingSparkPlug
Before setting up your lawn mower, disconnect the
spark plug wire from the spark plug, and ground it
against the engine. See Figure 2.
Attach the spark plug wire to a bolt on the engine to
ground it.
AssemblingHandle
Remove grass bag from the unit and set it out of the
way. See Figure 3 (step 1).
Remove any packing material which may be
between the upper and lower handles for shipping
purposes.
2. Lift lower handle
Move bag
away
3. Lift u
_-Spark Plug
Figure 2
Figure 3
Raise the lower handle in the direction shown in
Figure 3 (step 2) till it snaps into place.
Loading ...
Loading ...
Loading ...