Loading ...
Loading ...
Loading ...
Installation
6
1 Installation
1.1 General installation instructions
• Proper installation is your
responsibility. Have a qualified
technician install this oven. Make sure
you have everything necessary for
correct installation. It is the responsibility
of the installer to comply with installation
guidelines specified on the model/serial
ID plate. The model/serial ID can be
found on the internal frame of the oven
when the door is opened.
• Have your oven installed and
properly grounded by a qualified
installer, in accordance with these
installation instructions. Grounding is
mandatory according to the provisions of
the electrical system safety regulations. If
this appliance is connected to an outside
electrical power source, it must be
grounded in compliance with local laws,
or, if no local laws exist, in compliance
with the national ANSI/NFPA 70 code
of electrical regulations.
• Make sure that the voltage and
dimensions of the supply line correspond
to the information indicated on the
model/serial rating plate. A multi-pole
circuit breaker must be available on the
supply line with contact gap equal to or
greater than 3mm, located in an easily
accessible position near the appliance.
• Do not attempt to repair or replace any
part of your oven unless specifically
recommended in this manual. All other
service procedures should be performed
by a qualified technician.
• This oven is not suitable for installation
and use in mobile homes or campers.
• Electrical grounding is required. See
the “Electrical requirements” section. It is
the customer’s responsibility to:
1. Contact a qualified electrical installer.
2. Ensure that the electrical system is
adequate and in compliance with the
national ANSI/NFPA 70 ELECTRICAL
CODE - latest edition - or the
CANADIAN ELECTRICAL CODE,
C22.11 - 1982 and C22.2 No. 01982
- or latest edition - and all local codes
and ordinances.
IMPORTANT: Observe all codes and
ordinances in force.
Loading ...
Loading ...
Loading ...