Loading ...
Loading ...
Loading ...
OCCURRENCE POSSIBLE CAUSE SOL UTION
Wash load too wet after Washer is overloaded. Do not overload washer. See Washing
spin. Procedures.
Load is out of balance. Rearrange load to allow proper spinning.
Drain hose is kinked. Straighten drain hose.
Water does not enter Washer lid is open. Close washer lid. The washer will not fill with
washer or it enters water, agitate or spin when the lid is open, and
slowly, will only start to do so if the lid is closed.
Water supply is not adequate in area. Check another faucet in the house. Wait until
water supply and pressure increase.
Water supply faucets are not completely Fully open hot and cold faucets.
open.
Water is being used elsewhere in the house. Water pressure must be at least 30 psi (260 kPa).
Avoid running water elsewhere while washer is
filling.
Water level does not Water inlet hoses are kinked. Straighten hoses.
cover load.
Washer is overloaded. Do not overload washer. Dry load level should not
be higher than top of agitator vanes.
Warm or hot water is not
hot enough.
Hot water heater isset too low or isa distance
from washer.
Measure hot water temperature at nearby faucet
with candy or meat thermometer. Water
temperature should be at least 120°F (50°C).
Adjust water heater as necessary.
Hot water is being used elsewhere in the
house.
Avoid using hot water elsewhere before or during
washer use. There may not be enough hot water
available for proper cleaning. If problem persists,
your hot water system may be unable to support
more than 1 use at a time.
To conserve energy, the temperature of the See Operating Instructions for your washer.
hot wash is regulated.
Water in washer does Drain hose is kinked or clogged. Clean and straighten the drain hose.
not drain or drains slowly.
Water leaks. Loose fill hose connection at faucet or washer. Check and tighten hose connections. Install rubber
sealing washers provided.
House drain pipes are clogged. Unclog drain pipes. Contact plumber if necessary.
Oversudsing. Use less detergent.
incorrect wash and rinse Hot and cold water hoses are connected to Connect hot water hose to hot water faucet and
temperatures, wrong supply faucets, cold water hose to cold water faucet.
Water is entering washer Drain hose standpipe is incorrect height. Standpipe must be a minimum of 33" (83.82 cm)
but tub does not fill. high to prevent siphoning. See INSTALLATION
INSTRUCTIONS.
Water is present in tub Lid lock malfunction. Do not bypass lid lock. Call your authorized
after wash cycle is servicer.
complete.
The drain and spin cycles Lid lock malfunction. Do not bypass lid lock. Call your authorized
did not occur, servicer.
10