Loading ...
Loading ...
Loading ...
Use and Care Guide
Printed in USA 6 0213
4. Clean the condenser by using a vacuum
cleaner to remove loose debris (leaves, dirt,
etc.) that may have accumulated inside the
grille.
5. Reinstall the front grille.
6. Clean the interior of the unit using stainless
steel cleaner and polish.
7. Clean the exterior of the unit using stainless
steel cleaner and polish.
NOTE: Do not place a cover over the unit. While
not required, you may choose to remove the unit
from the outdoor location and store indoors.
CAUTION
Operating unit at
temperatures lower than
those recommended will void the warranty.
Spring Start-Up
This process should occur after the daily low
temperature is above these temperatures:
Freezer models: 32° F
Refrigerator models: 38° F
Beverage Center: 42° F
Wine Reserve: 45° F
1. Remove the grille.
2. Check the condensing unit to ensure it is clear
of loose debris, and clean as necessary with
vacuum cleaner.
3. Reattach front grille to the unit.
4. Clean the interior of the unit using stainless
steel cleaner and polish.
5. Clean the exterior of the unit using stainless
steel cleaner and polish.
6. Plug the unit into the electrical receptacle or
turn on the circuit breaker.
7. Press the OFF button one time to turn the unit
on. The controller display will show the actual
temperature inside the cabinet.
8. The cooling process will begin to bring the
unit to the set temperature. It’s recommended
you run the unit for 24 hours to stabilize the
operating temperature before using.
Shallow Depth Factory
Temperature
Setpoint
HH24RS 38° F
HH24BS 42° F
HH24WS 55° F
Adjust the temperature as follows:
Colder Temperature: Turn the adjusting screw
clockwise (to the right).
Warmer Temperature: Turn the adjusting screw
counterclockwise (to the left)
Temperature Control OFF: Turn the adjusting
screw completely counterclockwise to the OFF
position until a click is heard.
NOTE: The condenser fan motor turns off with
the compressor.
SEASONAL MAINTENANCE
FOR OUTDOOR APPROVED
MODELS
Winterizing
This process should occur when the daily low
temperature is at or above the temperatures
stated below:
Freezer models: 32° F
Refrigerator models: 38° F
Beverage Center: 42° F
Wine Reserve: 45° F
It is best to winterize your unit before the low
temperarature listed.
1. Turn unit to the OFF position by pressing the
OFF button on the controller. The controller
displays the word “OFF”. (If power cord is
accessible, unplug the power cord. If not,
turn off the circuit breaker to the electrical
receptacle the cabinet is plugged into). For
C-Series units, unplug or turn off circuit
breaker.
2. Remove all contents from the unit.
3. Remove the front grille.
Loading ...
Loading ...
Loading ...