Loading ...
Loading ...
Loading ...
12
Installation Instructions
Holding-Bracket Centerline Distance
Models RNHP, RNHE A
3012, 3018 12 1/2 in (31.8 cm)
3612, 3618 7 1/8 in (18.1 cm)
4812, 4818 17 in (43.2 cm)
Marking the Centerlines and Brackets
Attaching the Brackets to the Wall
Rotating the Blower(s) for Rear
Exhaust
Perform this procedure before you hang the hood.
WARNING
• Only install the hood if the electrical service provided
meets the hood’s specifications.
• Observe all governing codes and ordinances during
installation. Contact your local building department for
details.
• Only a qualified technician may install this built-in appli-
ance. Multiple persons are needed to lift the hood into
place. The owner shall verify proper installation.
Top Exhaust
Rear Exhaust
The blowers (fans) can be rotated so air vents out the back
of the hood.
The hood comes from the factory in the top-exhaust con-
figuration; if you intend to use that configuration, you do
not need to alter the blower’s position.
If, however, the hood will be installed in a rear-exhaust
configuration, the blowers must be rotated so the exhaust
vents through the rear of the hood.
Tools Needed
5/16” Nut driver
Cable ties
• AHT10 Transition kit (option), metal screws, foil tape
• 10” ducts, ducting material
8” Duct and ducting materials
Phillips screwdriver
Installing the Holding Brackets,
cont.
Loading ...
Loading ...
Loading ...