Loading ...
Loading ...
Loading ...
10
Controls
Heating mode
Cooling mode
Each time the heating mode is selected, it conducts a
short calibration cycle. Airow will be automatically
controlled during this cycle. Once the calibration
cycle is complete, it will revert to the selected airow
speed.
On rst use, the heater will default to a temperature
1°C higher than the current room temperature.
Thereafter, the heater will remember the last target
temperature set.
Select the desired room temperature. Pressing red
increases the target temperature, blue decreases
it. The heater will not operate unless the target
temperature is above the room temperature.
Press the blue thermostat control button to change the target
temperature to 0°C. The power button light will change from
red to blue. To adjust the airow speed use the airow speed
control.
Press the red thermostat control button until the digital display
shows the desired target temperature. The power button light
will change from blue to red.
For best results turn on the oscillation control.
Select a high ow of air.
Select a low ow of air.
To return to heating mode
Whole room
Spot heat
1. Power on 2. Thermostat control
Loading ...
Loading ...
Loading ...