Loading ...
Loading ...
Loading ...
78
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
2. Place the supplied speaker setup microphone in the listening position, and
connect to the SETUP MIC jack on the main unit.
SETUP MI
C
When putting the speaker setup microphone on a tripod, refer to the illustration
when putting it in place.
3. Conrm a test tone is output from the subwoofer and press ENTER.
4. Press ENTER. Then, test tones are output from each speaker, and the
connected speakers and the noise in the surrounding environment are
automatically measured.
5. After the results of the measurements are displayed, select "Next", press
ENTER on the remote controller, and the test tones are emitted again, and the
unit automatically makes settings such as the optimum volume level and the
crossover frequency.
6. When the measurement is completed, the measurement result is displayed.
Press the cursors / on the remote controller to check the settings. Press
ENTER when "Save" is selected to save the settings.
7. Disconnect the speaker setup microphone.
2. MCACC Data Check
You can check the number of speaker channels connected and the content and
values you have set for each of the speaker settings.
Speaker Setting: You can check the number of speaker channels connected
and the large and small settings you have set for the low range reproduction
capabilities for each of the speakers.
Channel Level: You can check the output level settings for each of the speakers.
Speaker Distance: You can check the distance from each speaker to the
listening position.
4. Audio Adjust
1. Dual Mono / Mono
Change the settings of multiplex audio playback.
Setting Item Default Value Setting Details
Dual Mono Main Set the audio channel or language to be output
when playing multiplex audio or multilingual
broadcasts, etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels are output at
the same time.
• For multiplex audio broadcasts, pressing the
button on the remote controller will display "1+1"
on the main unit’s display.
Mono Input
Channel
Left + Right Set the input channel to play 2-ch digital sources
such as Dolby Digital, or 2-ch analog/PCM sources
in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels
Loading ...
Loading ...
Loading ...