Loading ...
Loading ...
Loading ...
22
The oven is not cooking evenly
Do not use a baking tray with dimensions larger than those
specied in the section on ‘General Oven Tips’.
If you are cooking a large item, be prepared to turn it round
during cooking.
If two shelves are used, check that space has been left for
the heat to circulate. When a baking tray is put into the oven,
make sure that it is placed centrally on the shelf.
Check that the door seal is not damaged and that the door
catch is adjusted so that the door is held rmly against the
seal.
A dish of water when placed on the shelf should be the
same depth all over. (For example, if it is deeper at the back,
then the back of the cooker should be raised up or the front
lowered.) If the cooker is not level, arrange for your supplier
to level it for you.
Oven not coming on
Is the power on? If not, there may be something wrong with
the power supply.
Is the cooker supply on at the isolator switch?
Oven temperature getting hotter as the cooker gets older
If turning the temperature down using the oven control knob
has not worked, or has only worked for a short time, then
you may need a new thermostat. This should be tted by a
qualied service person.
Oven light is not working
The bulb has probably burnt out. You can buy a replacement
bulb (which is not covered under the warranty) from a good
electrical shop.
Ask for a 40 W – 230 V halogen lamp (G9) (Fig. 7.5).
Turn o the power at the circuit breaker.
Before removing the existing bulb, turn o the power supply
and make sure that the oven and bulb have cooled. Open the
oven door and remove the oven shelves.
Remove the bulb cover by turning it a quarter turn, counter-
clockwise. It may be very sti (Fig. 7.6).
Taking care to protect your ngers with a glove in case the
bulb should shatter, unscrew the old bulb.
Screw in the new bulb; screw back the bulb cover. Turn on the
circuit breaker and check that the bulb now lights.
The oven door is misaligned
The bottom hinge of either oven door can be adjusted to
alter the angle of the door (Fig. 7.7). Loosen the bottom
hinge xing screws and use the notch and a at bladed
screwdriver to move the position of the hinge to set the
hinge position (Fig. 7.8).
Retighten the hinge screws.
ArtNo.320-0007 Oven door hinge adjustment 2
Eect of hinge adjustment – exaggerated for clarity
Oven door omitted for clarity
Centre line of hinge pin
Fig. 7.5
Fig. 7.6
Fig. 7.7
Fig. 7.8
Loading ...
Loading ...
Loading ...