Loading ...
Loading ...
Loading ...
assembly
TOOLS NEEDED
#2 PHILLIPS SCREWDRIVER
PUTTING YOUR HOME-N-SHOP VAC
TOGETHER
flexible locking tabs. With locking tabs in "out"
position, lift lid away from tank.
_DRUM
OUT '
FLEXIBLE LOCKING TAB
'__lj= / _ ! PUSHING
'f'_b. PULLING
| OUT
|FLEXIBLE
LOCKING
TAB
2. Place dust drum from Home-N-Shop Vac upside
down. Put together caster assembly as shown.
A. Connect the two cross bars with machine
screwand nut-- notice the offsgt in cross bars
-- arrange cross bars as shown in sketch so ali
mounting stems are the same height. Snap
mounting stems into bottom of dust drum.
MOUNTING STEMS
\ CROSSBARS
NUT
® \
CASTER
CASTER --
I
THREAD CUTTING SCREWS---_ _
B. Slip each caster foot over ends of cross bars
and insert thread cutting screws through
caster, caster foot and into cross bar. Do not
tighten screws until all parts are in place. Press
caster feet against dust drum and tighten
sc rews.
_DUST DRUM
4
Loading ...
Loading ...
Loading ...