Loading ...
Loading ...
Loading ...
8
Load plastic items so the force of the spray does not move
them during the cycle.
To avoid chipping, do not let stemware touch other items.
Small bowls, pans, and other utensils can be placed in the
top rack. Load bowls in the center section for best stability.
Cup shelves (on some models)
Fold down the extra shelf on the left-hand or right-hand side of
the top rack to hold additional cups, stemware or long items such
as utensils and spatulas.
NOTE: The features on your dishwasher may vary from those
shown below.
Light item clips (on some models)
The light item clips hold lightweight plastic items such as cups,
lids, or bowls in place during washing.
To move a clip
1. Pull the clip up and off the tine.
2. Reposition the clip on another tine.
Side clip (on some models)
The side clip holds lightweight plastic items such as cups, lids, or
bowls in place during washing.
To move a clip
1. Pull the clip up and off horizontal rack wire.
2. Reposition the clip on another horizontal rack wire.
Utensil clip (on some models)
The utensil clip holds specialty cooking items (wooden spoons,
spatulas, and similar items).
To move a clip
1. Pull the clip up and off horizontal rack wire.
2. Reposition the clip on another horizontal rack wire.
Adjustable 2-position top rack (on some models)
You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Raise the top rack to accommodate items up to
9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or
lower the top rack to accommodate items up to 11" (28 cm) in
both the top and bottom racks. Two adjusters are located on
each side of the top rack. Each adjuster has 2 preset positions.
The high and low positions are marked on the adjuster.
To adjust the top rack
1. Hold the top rack with one hand near the adjuster.
2. With the other hand, pull out the top of the adjuster.
3. Raise or lower the rack to one of the preset positions.
4. Release the adjuster.
5. Repeat the steps for the remaining adjusters.
NOTE: The top rack must be level.
Loading ...
Loading ...
Loading ...