Loading ...
Loading ...
Loading ...
SOAP
Page 4 of 4
Part Number 7117719 / English
REV 0 - 12/23/2021
Copyright 2021. All Rights Reserved.
1. Attach the open
end of the soap hose
to the barbed tting
on the pump.
1. Turn on the
burner by clicking
the burner switch to
the ON position.
2. Adjust the water
temperature by rotating
the temperature control
knob left or right.
2. Place the
ltered end of
the soap hose
into a container
of soap or ll
the soap tank
NOTE: Use
only soaps that
are approved
for pressure
washer use.
3. Insert the black
nozzle into the
spray wand.
NOTE: Soaps will
not siphon if the
black soap nozzle
is not installed on
the spray wand.
Start the Engine:
Igniting and Adjusting Water Temperature:
Using Chemicals:
NOTE: After using soap, place the ltered end of the soap hose into a container of clean water and run pressure washer drawing clean water through the
hose and pump until the system is thoroughly rinsed. If soap or other chemicals remain in the pump, the pump could be damaged. Pump damage from soap
or chemical residue is not covered under warranty.
Pressure Washing Tips:
1. A wider spray equals faster cleaning, while tighter spray equals
deeper cleaning.
2. Do not aim the nozzle straight at a surface. Hold the wand at a
45-degree angle to the surface and at a distance that cleans well
without causing damage.
3. Keep the nozzle about 4-feet away from siding to prevent damage
to surfaces.
4. Wash siding by starting at the bottom and working your way up,
then rinse from the top down.
5. Avoid driving water up behind siding.
6. For even cleaning, use overlapping strokes.
7. Work in smaller areas and do not let soap dry on surfaces.
Selecting a Nozzle:
NOTE: Always make sure the nozzle is properly installed by tugging on it after
inserting it into the quick connector before using the pressure washer.
Color
Spray
Pattern
Uses Surfaces
Red 0°
Spot cleaning
hard, unpainted
surfaces and
high-reach
areas
Unpainted metal and concrete
DO NOT use on wood
Yellow 15°
Intense cleaning
of unpainted
surfaces
Grills, driveways, concrete and
brick walkways, unpainted brick
and stucco
Green 25°
Standard
cleaning
nozzle for most
applications
Yard tools, sidewalks, lawn
furniture, unpainted siding, stucco,
gutters, eaves, concrete, and brick
surfaces
White 40°
Cleaning painted
or delicate
surfaces
Autos, trucks, RVs, boats,wood,
painted brick, painted stucco, vinyl,
and painted siding
Black Soap
Applying
cleaning
solutions
Safe on all surfaces. Always verify
compatibility of cleaning solutions
prior to use.
7. Select the correct nozzle for your
cleaning job per nozzle selection chart in
this document and install it onto the lance
by pulling the quick-connect coupler back,
inserting the nozzle, then releasing the
coupler allowing it to snap back in place.
6. Turn on the water supply, aim
the spray gun in a safe direction,
then squeeze and hold the trigger
for at least 60 seconds or until the
water runs steady and all the air
is purged from the pump, heater
coil and hoses.
Please refer to the engine manual for engine starting instructions.
NOTE: DO NOT try to ignite the burner unless the engine is running.