Loading ...
Loading ...
Loading ...
Preparation
IMPORTANT INFORMATION
1. Before you begin, locate the instructions and hardware. Be sure you have all of the parts and can identify
them.
2. To avoid scratching the finish, assemble the product on a soft, non-abrasive surface such as carpet or
cardboard.
3. Assembly of this product may require more than one person.
4. Selectalocationthatisnotsusceptibletomoisture,dustandisawayfromhightrafclocationsandthings
thatmanycatchreorblockopeningssuchasdrapes,pillows,furnitureetc.
5. It is strongly recommended that the screws be screwed into the wall studs where possible. If the wall studs
cannot be used, wall anchors must be used.
CAUTION: Enclosed wall anchors (BB) only can be use on the concrete wall.
6. Forthebesteffectinstallthereplaceoutofdirectsunlightandawayfromoverheadlighting.
Tools Required
Philips Screwdriver Hand Drill Hex Key
5
ASSEMBLY INSTRUCTIONS
Site Selection
WARNING: This appliance is hot when in use. To avoid
burns, DO NOT let bare skin touch hot surfaces. Keep
combustible material, such as furniture, pillows, bedding,
papers, clothes and curtains, at least 3 feet from the front of
the heater and keep them away from the side and rear.
Minimum clearance of the replace to the adjacent wall
Sides ------------------------------- 6 inch / 15 cm
Floor ------------------------------- 6 inch / 15 cm
Top ------------------------------- 6 inch / 15 cm
Back ------------------------------- 0 inch / 0 cm
Select a location that is not susceptible to moisture, dust and is away from high trafc locations and things that many
catch re or block openings such as drapes, pillows, furniture etc.
Min.
6 inch
Min. 6 inch
Min. 6 inch
Loading ...
Loading ...
Loading ...