Loading ...
Loading ...
Loading ...
This Owner's Guide provides specific operating instructions
for your model, Use the freezer only as instructed in this
Owner's Guide, Before starting the freezer, follow these
important first steps.
INSTALLATION
* Choose a place that is neara grounded electrical outlet,
Do Not use an extension cord or an adapter plug,
o For the most efficient operation, the freezer should
be located where surrounding temperatures will not drop
below 40 ° F (5° C) or exceed 110° F (43° C),
o Allow the following clearances for ease of installation,
proper air circulation, and electrical connections:
Sides 3/8"
Back & Top 1"
Freezer
Jnsta]mation
o Do Not bbck the toe grHb on the bwer front of your
freezer, Sufficient air circuUation is essentiaUfor the proper
NOTE: The exterior wafts of the freezer may become quite
warm as the compressor works to transfer heat from the
inside, Temperatures as much as 80° F warmer than room
temperature can be expected, For this reason it is particu-
larly important in hotter climates to allow enough space for
air circulation around your refrigerator,
DOOR OPENING
NOTE: If your freezer is placed with the door hinge
side against a wall, you may have to allow additional
space so the door can be opened wider.
LEVELING
The freezer must have all bottom corners resting firmly on a
sow floor, The floor must be strong enough to support a fully
loaded freezer, NOTE: it is Very mmportant for your freezer to
be level in order to
function properly, if the
freezer is not leveled
during installation, the
door may be misaligned
and not close or seal
properly, causing
cooling, frost, or
To Levet Freezer:
Unpacking and Leveling
Leve_ing Feet
Crating
screws and wood base,
use a carpenter's level
to level the freezer from A,,a<2>w,,o_B....
front-to-back, Adjust the "_
plastic leveling feet in UnpackingandLeveling
front,F2bubblehigher,sothatthedoordoses easilywhen left
halfwayopen,
LeveJing mnetructionefor aHRefdgeratodFreezer Pair:
, Remove two leg levelers provided in literature bag,While
unit is lying on its back wood skid removal, install both leg
levelers in rear of unit,
, Level door of first unit using all four levelers and slide unit
into place, Recheck for levelness and adjust if necessary,
, Measure distance from floor to bottom of door on first unit,
Adjust and level second unit so door height matches,
Leg Level Adjustments
One fuji turn of aii four leg levelers wiii raise door 5/32",
One fuji turn of both front leg levelers wiii raise door 3/16"
and tilt top of door back 7/16",
, One furlturn of both rear leg levelers will lower door 1/32"
and tilt top of door forward 7/16",
, One fuji turn of both side leg levelers wiii raise door 3/16"
and tilt top of door 3/8",
, Slide second unit into place leaving a minimum gap of 3/16"
between units fordoor swing clearance,
This last step may require at bast one extraction of the
second unit to properly align units in a "built-in" application,
_To allow doorto close and sealproperly, DO
NOTlet food packagesextend past the front of shelves,
Shelf Front --
Loading ...
Loading ...
Loading ...