Loading ...
Loading ...
Loading ...
Cycle 1
150 lpi
5-06-04 on stage_set-up_guide_12.qxp
K
TRIM
FOLD
TRIM
Step 2. Choose correct iPod
adapt
or type. Press iPod adaptor
int
o on stage.
Step 3. Plug power adaptor into on
s
tage. Connect adaptor to wall out-
l
et.
Step 4. If using iPod with bottom
c
onnector, dock iPod into front
c
onnector of on stage.
Symptom
No sound from on stage
speak
er system.
Clicking/Ticking noise from
speakers
Possible problem
No power to system.
Power adapter plug not
inserted correctly.
No volume or low volume.
Input source is low.
Incorrect power supply
plugged int
o A/C jack or
firewire port.
Solution
Ensure power supply is connected to live
po
wer source and properly connected to on
st
age. Please note: When on stage is pow-
ered, a green power LED should illuminate.
Touch the volume “Up” (
+
) pad on the volume
control to unmute and/or increase the system
volume level.
Note: Touching the volume “Down” (
-
) pad
lowers the system volume. Touching both (
+
)
and (
-
) volume control pads at the same time
will mute the system.
Increase the volume level on the audio source
device.
Disconect non-JBL power supply.
Troubleshooting
on stage specifications*
Frequency range: 100Hz–20kHz
Po
wer consumption: 20W maximum
Transducers: (2) 1-inch full range per
channel
Amplifier output power: 6 Wrms per
channel
Dimensions:
6.75" (17.1 cm) diameter
1.5" (3.8 cm) tall
Weight: 1.1 pound = 0.5 kg
Sound quality can be affected by the
amount of file compression.
USE ONLY JBL approved power supplies
listed on the product label.
on stage Easy Setup Guide
If y
ou have any questions, or need further assistance, please visit www.JBL.com.
*These specifications are subject to change without notice.
6
St
ep 6.
If needed, c
onnect
Auxiliary input ( desktop or laptop
computer) to AUX connector.
Step 5. If using iPod Classic, connect
auxiliary c
able from headphone to
AUX jack on back of on s
tage.
Step 7. Press power button on
back of on stage. Green LED will
light when on stage system is on.
St
ep 8.
Adjus
t Volume using “+”
to increase and “-” to decrease.
Press both to Mute the on stage.
Press either button to unmute.
Symptom
No Power. Green LED in power
button is not on.
iPod volume control does not
increase audio volume.
Possible problem
Wall adaptor is not plugged into on
stage correctly.
Wall adaptor is not receiving AC
power.
Power button is not depressed.
iPod volume control only controls
volume output to the headphone
jack.
Solution
Check connection of wall adaptor.
Place wall adaptor in a known powered outlet. Test outlet with a lamp
or other device.
Press power button located at the rear of the unit. Green LED will
illuminate.
Use the on stage volume control buttons for volume control when the
iPod is docked on the on stage unit.
7
www.JBL.com
This pr
oduct is intended to be supplied by a Listed Direct Plug-in Power Unit marked Class 2 and Output rated 18 Vdc minimum 0.8A.
Step 1. Unpack on stage, wall adaptor,
iPod adaptors and cable. Read this
instruction sheet completely.
Loading ...
Loading ...
Loading ...