Blomberg WM98400SX User Manual

Loading ...

22 / English

Front-Loading Automatic Washer

Installation Instructions

The water pressure must be between 15-145 psi (1-10 bar) for the

proper operation of this washer. 1 bar corresponds to more than 2.1

gallons (8 liters) per minute flow rate with a fully open faucet. Water

inlet hoses and valves should withstand a water pressure of 145

psi (10 bar) at maximum. If the pressure is higher than 145 psi, a

pressure-reducing valve must be installed before the water inlet. If the

water pressure is lower than 15 psi (1 bar), water fill time may extend

or water inlet valve may shut off completely.

•Hotwatersupplytemperaturemustnotexceed140˚F(60˚C).(Ideally

120˚F (48˚C))

•Donotconnectthewashertoanunpressurizedwaterboilersince

water pressure may not be adequate for proper operation.

•Donotremovethefilterslocatedonthewatersupplyhoses(on

faucet/hose and hose/inlet valve connections).

•Alwaysusegenuine“Blomberg”watersupplyhoseswhen

connecting with this washer. Old or worn-out hoses must not be

reused. It is not advised to extend inlet or drain hoses, if necessary

consult your dealer or technical service about hose extensions.

•Hotandcoldwaterfaucetsmustalwaysbeeasilyaccessibletothe

user.

•Attheendofawashingday,turnoffwaterfaucetstopreventany

leakage or water damage that may occur due to a faulty condition

of the appliance.

•Checktheapplianceandinlethoseconnectionsforwaterleakage

after each use. If there is leakage, turn off the appliance and water

faucets and call service.

•Checkthewaterinletanddrainhoseconnectionsregularlyforany

leakage. Hoses should be replaced every 5 years.

•Ifthereisnohotwatersupply,hotwatervalvemustbeconnected

to a cold water faucet nevertheless. Both water valves should be

connected to water supply for proper operation of your washer.

Loading ...

Blomberg WM98400SX 2.5 cu. ft. 24 Inch Front Load Washer