Loading ...
Loading ...
Loading ...
TOADJUSTMOTIONCONTROLLEVER
Themotioncontrolleverhasbeenpreset
atthefactoryandadjustmentshouldnot
benecessary.
Ifforanyreasonthemotioncontrollever
willnotholditspositionwhileat aselected
speed,it may be adjusted a_tthe fdction
pack located on the right side of transmis-
sion.
• Park tractor on level surface. Stop trac-
tor by turning ignition key to "OFF* posi-
tion, and engage parking brake.
• Adjust motion control lever by tightening
adjustment Iocknut one halt (1/2) turn.
NOTE: If for any reason the effort to move
the motion control lever becomes too
excessive, reverse the above adjustment
procedure by loosening Iocknut 1/4 to 1/2
tum.
Road test tractor after adjustmentand
repeat procedure if necessary.
Locknut
TRANSMISSION REMOVAUREPLACE-
MENT
Should your transmission require removal
for service or replacement, it should be
purged after roinstallaUon and before
operating the tractor. See =PURGE
TRANSMISSION" in the Operation section
of this manual.
TO ADJUST STEERING WHEEL ALIGN-
MENT
If steedng wheel crossbars are not hod-
zontal (left to right) when wheels are posi-
tioned straight forward, remove steedng
wheel and reassemble per instructions in
the Assembly section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not
adjustable on your tractor. If damage has
occurred to affect the front wheel toe-in or
Camber, contact your nearest authorized
service center.
TO REMOVE WHEEL FOR REPAIRS
• Block up axle securely.
• Remove axle cover, retaining dng and
wseh_rs to allow wheel removal (roar
wheel contains a square key - Do not
lose).
• Repair tim and reassemble,
• On rear wheels only;,align groovesin
roar wheel hub and axle. Insertsquare
key.
• Replace washers and snap retaining
dng securely in axle groove.
• Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, tire sealant
may be purchased from your local parts
dealer.Tire sealant also prevents tire dry
rotand corrosion.
Washers A
Retaining _ mHf [(._'_L'_
Ring'__Jl
Axle_ver '_'__'_y-J'
(Rear Wheel Only)
TO START' ENGINE WITH A WEAK
BATTERY
ACAUTION: Lead-acid battedes gener-
ate explosive gases. Keep sparks, flame
and smoking materials away from batter-
ies. Always wear eye protection when
around batteries.
If your battery is too weak to start the
engine, Jtshould be recharged. (See
•BATTERY" in the MAINTENANCE sec-
tion of this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: Your tractor Is equipped
with a 12 volt negative grounded system.
The other vehicle must also be a 12 volt
negativegrounded system. Do not use
your tractor battery to start other vehicles.
TO ATrACH JUMPER CABLES -
• Connect each end of the RED cable to
the POSITIVE (+) terminal of each bat-
tery, taking care not to short against
chassis.
• Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of fully
charged battery.
• Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES_REVERSE
ORDER -
• BLACK cable first from chassis and
then from the fully charged battery.
• RED cable last from both battedes.
25
Loading ...
Loading ...
Loading ...