Loading ...
Loading ...
Loading ...
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
brush sprock-
et.
Motor
Drive
Sprocket
Agitator End Cap
NOTE: See
PARTS AND FEATURES for belt number.
2. Place agitator
assembly back into
Power-Mate®.
Cover Base
3. Line up
front of
cover and
base. Rest
cover on
front edge
of base as
shown.
4. NOTE: On dirt sensor models be sure
that the board is upright and the wires are
tucked back as shown.
5. Rotate cover back. Press cover firmly
until side and rear latches snap into
place. Turn Power-Mate ®upside
down and replace two
(2) cover
screws.
_lde Hear
t.al(:h i.a_hu_
1. Remove Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
"-_Pushln_
And Turn | |
2. Push in and tum
bulb counterclock-
wise, then pull out
to remove.
_Pushln [ _ 3. Push in and turn
AndTurnI / bulb clockwise, to
_ eplace. Bulb must
not be higher than
15 Watts(130 Volts).
4. Reinstall Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
NOTE: See PARTS AND FEATURES for
bulb number.
19
Loading ...
Loading ...
Loading ...