Loading ...
Loading ...
Loading ...
11 ENGLISH
Supplying water from a tank/
reservoir
You can supply water from a tank or reservoir instead
of a faucet.
Replace the water hose connector with the suction hose
set. When connecting the suction hose set, disconnect
the lter case from the hose and attach the lter case to
the inlet of the high pressure washer. Then, connect the
hose to the lter case.
NOTE: When removing/connecting the hose from/to
the lter case, turn the sleeve while holding the hose
so that the hose does not rotate with the sleeve.
1 2
3
4 5
6
8
7
► 1. Tank/reservoir 2. Suction hose set 3. Water hose
connector 4. Hose 5. Filter case 6. Inlet on the high
pressure washer 7. Hose band 8. Sleeve
CAUTION: When attaching the sleeve to the
lter case, be careful not to hurt your hand by the
hose band.
NOTICE: Always use Makita's suction hose set.
NOTICE: Always keep 1 m (3.28 ft) or less in
height between the inlet of the high pressure
washer and the water surface. Otherwise, the high
pressure washer will be unable to take the water up
into the pump.
To introduce water into the hose, remove the nozzle
from the trigger gun and switch on the high pressure
washer while the trigger is squeezed. Once water is
ejected stably from the trigger gun, release the trigger
and attach the nozzle for your purpose.
1
► 1. Trigger gun
NOTE: When water is not ejected, detach the suction
hose set and soak it in water. Then reconnect it to the
high-pressure washer.
1
► 1. Suction hose set
When using the container as a water
tank
You can use the container supplied with the high pres-
sure washer (country specic) as a water tank.
1. Empty the container and feed water in it.
1
► 1. Full water level line
Loading ...
Loading ...
Loading ...